Pierfrancesco Fagiani
Pool Senior Consultant

12/05/2022

We were recently asked to renovate a swimming pool in the province of Macerata, Italy, which had been built by one of our competitors just five years earlier.

Once again, we found several problems, both in terms of workmanship and appearance. Let's take a closer look.

 

Rust on the Steel Structure After Just Five Years

This can happen when low-quality steel is used and the customer is not given adequate long-term warranties.

The result? The entire structure is covered in rust and needs to be treated again.

 

   

 

A Pool Liner Installed in “Three Layers”

We've never seen anything like it! We came across a truly baffling installation, with three layers of pool liner overlapping and bonded together.

 

   

 

Poorly Installed Pool Coping

As you can see in the photos, the coping was installed next to the groove rather than over it.

This leaves the metal profile around the pool perimeter exposed, even though it should be concealed from view. The result is far from attractive.

 

   

 

Numerous Wrinkles in the Pool Liner Around the Edge and Inside the Pool

The photos speak for themselves: a pool liner should be smooth and properly stretched, with no visible wrinkles or bulges.

In this case, however, there are numerous wrinkles both around the pool edge and inside the pool. These defects point to a poorly executed installation.

 

   

 

A Wall Inlet Used Instead of a Main Drain

Here we can see a fitting normally used to circulate water along the pool walls, installed in place of a main drain.

A main drain is a dedicated fitting installed at the bottom of the pool. Depending on the system design, it can help circulate water, draw in debris that settles on the bottom and assist with draining the pool when necessary.

These components have different characteristics and functions. A wall inlet and a main drain are not interchangeable at will.

 

 

 

Deformation of the Plant Room

The indentation visible in the wall of the plant room is a sign of deformation. This can occur when the surrounding soil exerts excessive pressure on the walls.

If the backfilling is carried out correctly, following the manufacturer's instructions and the procedures required for that particular structure, the risk of this kind of deformation can be reduced.

 

 

 

Trust the True Specialists!

Our advice is always the same: don't choose a swimming pool based solely on price or the best deal you can find.

And above all, don't entrust the construction of your pool to the local builder down the road just because they offer you a lower price!

Look for a true professional who knows what they're doing and can deliver an outstanding result.

Because a swimming pool, just like a house, is an investment designed to last for years. So play it safe and trust the true specialists!

If you'd like to receive professional advice from our team, contact us by email or phone.